Archive

Archive for November, 2014

Glass to Glass Hinges and Fixed Panels

Hello,

I saw your blog and I wanted to know if you think our shower doors are safe. We got them installed today and because the hinges are not attached to the wall the entire panel moves when you open the door. It takes effort to open the door. The track is adhered to the walls and saddle with silicone. Will that soften over time? My fear is this thing will fall down over time.

Thank you for your input.

Jennifer

photo 2         photo 3

Hi Jennifer,

I know exactly what you are talking about. There is a standard formula for the maximum width a fixed panel should be if it has a door hinging from it. It varies a little depending on the thickness of the glass (1/2″ or 3/8″). If the panel exceeds the recommended width, the whole enclosure will move the way that you are describing.

I can’t make a judgement call based on your photos since there are a lot of factors that I am unable to determine. Chances are that your shower enclosure is safe. I doubt that the force required to open the door will soften over time. The hinges are spring loaded to cause them to center themselves… that is the resistance you feel when you pull on the door.

It is also possible to add additional support to the top of the fixed panel if you feel you might need it. You can talk to the original installers about that.

Best wishes,

-Chris

Seals in Steam Shower Enclosures

The frameless door in my steam shower is supposed to go to the ceiling. It was installed with a plastic edging that causes the door to scrape the ceiling so hard the paint comes off. I took off the plastic edging but there is now a gap at the top of the door. Is this normal? How should it have been done?

Virginia

Shower-14.jpg

Hi Virginia,

When people get a new steam shower they often think that the enclosure needs to be air-tight. Not only is this untrue, it is a bad idea. While it is obvious that you want to trap the steam inside of the shower so you can enjoy the hot, steamy goodness of it all, it isn’t necessary to become obsessed with the tiniest bit of steam escaping. Only you can decide if enough of the steam is staying in the shower.

It is always a challenge to keep the maximum amount of steam in while making the door operate correctly. It sounds like, in your case, it required removing one of the seals. You have to decide if the steam shower is functioning the way you think it should without it. If you feel that too much steam is escaping, it may be possible to attach an edge seal to the ceiling of the shower, rather than the glass. Sometimes that is a solution…

Let me know how things work out, OK?

Chris